Most of the GPX DVD player users are struggling to find the perfect working gpx universal remote control codes for their device. But now it is easy to find them out by using the below methods and we also mentioned some best codes which can be work for every gpx dvd player universal remotes. So check them below.

You are watching: Universal remote for gpx dvd player

If you would like to Program your universal remote control to a GPX DVD player then you must use the following remote codes.


Contents0.1 GPX DVD Player Universal Remote 4 Digit Codes0.2 GPX DVD Player Universal Remote 3 Digit Codes0.3 GPX DVD Player Universal Remote 5 Digit Codes1 How to Program GPX DVD Universal Remote Without Codes2 How to Program GPX DVD Universal Remote With Manual Method3 How to Program GPX DVD Universal Remote With Code Search

GPX DVD Player Universal Remote 4 Digit Codes

0944211409362390

GPX DVD Player Universal Remote 3 Digit Codes

826704098882

GPX DVD Player Universal Remote 5 Digit Codes


How to Program GPX DVD Universal Remote Without Codes

In the auto search method, all the universal remote codes are gone through scanning process in the remote. It scans one code at a time to find out the correct remote code that works with your remote to program the control. Follow the instructions given below:“Switch On” the smart device like “TV” that you want the universal remote to operate.“Turn on” the remote, tap on the device button (TV, DVD, CBL and OK/SEL) for 3 seconds. The LED light indicates the device is ready to program.Point out the remote to device and click on “CH+” & “CH-“ switches. Remote will show on/off signals. Press “up” or “down” key continuously till the device will turn off.Verify the code by clicking on “power” key. Device should turn on. If it starts, try changing the channel to verify that remote is programmed correctly.Now tap the “device” button to save the code. LED of Device will blink twice for confirming the code stored.

How to Program GPX DVD Universal Remote With Manual Method


By using the keycode we can easily program a universal remote and the keycode identifies the make and model of your equipment.First you need to “Turn The Device On”Press the “TV” on your “GPX DVD universal remote”Now press and hold the “Setup button” of the Universal Remote until it shows the “Light Flash” (It means it is in “Learning mode”) Finally enter the “Keycode” which you collected from the programing guide (Instructions Booklet)Once you’ve done this procedure, just “point your remote at the TV” and then “Press And Hold The Power” buttonYou can release the “Power Button” whenever the screen switches offThat’s all, your TV will work perfectly now with the universal remote control, if your device is not working then try to repeat the same procedure with the different code from the same part of the reference table.

See more: 36 Is 12 Of What Number - 36 Is 12 Percent Of What Number


How to Program GPX DVD Universal Remote With Code Search

If you couldn’t find the key code which works for the device at that time you can setup your universal remote to search mode for the correct one. Its a code in manual which forces the remote into the search mode

First of all “Turn The Device On”Now press and hold the “Setup” buttonEnter the “9-9-1” (three digit) codeNow hold down the “Power Button” on the remote and then press the Channel up them until the device in this case your tv “Turns Off”

The above method might take some extra time but it is very important to find your key code. Once you have done the above procedure your remote should be working for all the in functions.