On Off Switch Fits Belle MINIMIX 150 Cement Concrete Mixer 240V Electric

Product Information

We hope you found our common troubleshooting tips helpful. Please note that although the tips above can be used they will not always fix the problem, as every machine and problem has different factors attached to it. I think your wiring directions are great, and he has done it, but the thing still has a problem in the motor, and he now thinks it might be the capacitor. Over time the belt can wear down and eventually snap. If you find your motor is running but the drum isn’t rotating, it’s likely that the belt has broken. This is very common and is simply caused by lots of use. Whether your mixer is electric powered, or petrol powered, you can remove the side cover on the machine and replace the belt with ease. Broken Fan e. Mix: Let the mixer run until your materials are thoroughly mixed, then turn off the power switch.

Thanks for all that. When he got the mixer it would work if you held the switch in with your finger, so it was working. The wiring seems to be correct, thanks to your advice. hexagonal fitting at top. below that to the right is a single termianl - A1. then below that 4 terminals arranged as 2 rows of 2.Minimix 150 (04/2002 - 04/2007), Minimix 130, Maxi 140, Minimix 140, BWE40, BWE60, MiniAlpha, Minimix 110, Minimix 80, Minimix 60 c. Belt or Pulley Problems: Examine the drive belt and pulleys for wear and tear. A damaged or loose belt can prevent the drum from turning. Replace any damaged components.

If your Belle mixer starts and then stops unexpectedly during operation, consider these potential causes:We(He) bought at auction, but the switch was missing, and we have bought new switch, but are having problems wiring it. 110 Volt. If your machine is particularly old, or it hasn’t been serviced for a while, you may hear a grinding from the gearbox. This is caused by the gears wearing down over time. If your Belle cement mixer switch won't stay on, it could indicate a problem with the switch itself, loose wiring, or a fault in the motor. Consider the following steps: LLP, if i read this thread write he went off to the mixer at 18.29pm with the diagram and had not returned at 02.33am?