Liberon Decking Oil 5 Litre - Clear

Product Information

Stir the oil up, pour it out into a suitable container, and apply it to raised features such as railings using your paint brush – use long, even strokes as if you were painting a wall. Drying time is pretty sensible. Touch dry won’t take long at all if your timber was bone dry, but give it 24 hours after the last coat before you walk on it or put anything heavy down. It seems to darken a little for the first few days but brightens up as it fully cures. Pros: I have stripped the wood but the finish I have applied has not taken to the wood properly and has dried streaky. What should I do? Don’t panic, it’s a bit lively looking for the first week or two and then it’ll settle down to the colour you can see above 🙂 The age of the wood. Newer wood will have a higher moisture content and be tighter grained, allowing less oil to be absorbed than older wood which will look darker with the same oil.

As with any kind of refinish, wait until there are several days of clear weather forecasted with low chance of rain throughout. Allow to penetrate for 15 to 30 minutes, then apply the second coat without waiting for the first to dryWet the wood first with water and then sand smooth and leave to dry before applying water-based products. We will be happy to organise an exchange for the correct goods at no extra charge to yourself, please get in touch to organise this. Faulty Items

Oil is also really durable and is easy to maintain – you just need to keep it clean and touch it up every now and then. It’s very resistant to dirt and water so doesn’t require much upkeep at all.' The last piece of good news is the different colours – follow this link and you’ll be able to find the colour you’re looking for, be it lighter or darker. However, don’t trust in the picture on the product, still give yourself a chance of maintaining sanity and do a test patch 😀End grain absorbs more than flat grain hence why it is often darker. To avoid this brush on a coat of the solvent used in the finish ie. water or white spirit etc. on to the end grain before applying the finish. You can expect a slightly darker look for the first few days so don’t panic whilst it’s drying – it’ll eventually come up much clearer and shinier. It is vital when using stripper or bleacher to neutralise the wood thoroughly before applying any finishing products. We recommend Wax & Polish Remover to neutralise stripper and bleacher. Allow to dry for at least 24 hours before commencing the wax, oil or varnish process. When using water-based varnishes wood bleacher must be rinsed thoroughly to remove all residues.

Apply the stripper to the first section using long, even strokes. Do not walk on a section that has stripper on it. It is most likely that the timber was not fully dry when the woodstain was applied. It is vital that timber is completely dry before applying any finishing products. Beware that there may not have been any rain for a few days but there may have been a heavy dew overnight making the timber damp. After 20 minutes, apply another thin coat of oil on top of the coat already applied and then remove the excess oil with a cotton cloth. This will ensure the timber has soaked up enough oil to provide good protection. Then leave the area to dry for at least 24 hours before use. One thing you’ll notice is the busier areas will fade first, sorry for pointing out the obvious but it was more in relation to the manufacturer comments with regards to UV filters – you have no worry at all about this product failing through sunlight, the wear and tear is the only issue with oils. Wood has naturally occurring oils which seep out – as will this oil, or any other you choose from the review for that matter. Pros: Once you’re finished, leave the oil to dry out completely for around 24 hours, then repeat the process as necessary (two or three coats are generally required for the best results).

Liberon decking oil

Oils often come in natural colours or clear, and enhance the natural appearance of your wood,' explains Jimmy Englezos, senior product manager at Sherwin-Williams. An hour after the second coating has gone on, test out a patch by scrubbing it thoroughly with a scrubbing brush – make sure that the stain has been removed completely.