Motherboard for Anet A8 12V‑24V Main Board Module A8 3D Printer Motherboard USB Interface 3D Printer Platforms

Product Information

GOOD HEAT DISSIPATION: Supports 12-24V power input, and adopts high performance low on resistance MOS tube as the driver, with good heat dissipation and effectively solves the heating problem of the hot bed MOS tube. The CR Touch probe malfunctioned on initial probe deployment, triggering repeated probe deployments with an accompanying printer reboot cycle. Reliable Work: Adopt on board 4 way A4988 16 subdivision stepper driver board motor for good efficiency and stability.

You can change your choices at any time by visiting Cookie preferences, as described in the Cookie notice. Do not redistribute any products before they have arrived with you as inventory may vary and/or items might need repairs. I am attempting to provide a mount adapter frame for a PSU with a 50 mm x 150 mm mounting footprint.I'm trying to get a clean set of measurements of the Anet A8 mainboard and determine the exact positioning of the holes in both the board and frame. Assuming the port is USB for plugging in a USB BLE dongle there will be 5V, GND and D+ and D- so you should be able to work it out from this? Overall this board has been pretty good considering it's my first but I think it's time to think about upgrading.

This then seems to cause the BL/CR Touch probe to malfunction on initial probe deployment, triggering repeated probe deployments with an accompanying printer reboot cycle. I'm in a situation where I need to control current to the E stepper and am trying to figure out how. APPLICABLE MODEL: This motherboard is suitable for Anet A8 PLUS 3D printer, and can be directly connected to for Ramps1.Actually I found the defaults worked very well with my Anet A8 and so did not need to change them from what is specified in the configuration files.