Joint It Simple Jointing Mortar Dark Grey (1 x 20kg) - Large Size

Product Information

Available in three colours to match your patio, this grout will last a lot longer than other traditional grouts and mortars. Joint-It Simple is tightly vacuum packed inside a tough plastic bag to prevent any air from reaching the product before it is ready to be used.

Infinitepaving Ltd will be in no way liable to you for any loss, damage or expenses, either indirect or consequential, resulting out of the above situations or from the use of products purchased by you on Infinitepaving Ltd. Rain won’t crack the joints between your paving slabs which is why we say that Joint-It Simple is weed resistant. Oustanding finish | So simple to use, can be used in all weathers | Large tub, 20kg | Suitable for driveways up to 3 tonne lading | Stops weed growth | Permable to assist with drainage | Totally cement free, non staining at all | Starts to harden within 4 hours, can be walked in within 24 hours | Frost resistant | Made in Ireland | Available in 3 colours:- Neutral, Grey and Dark Grey. This active jointing compound is swept into the joints already soaked with water slabs compatible with all natural stone and concrete paving products.This moisture curing pointing compound is easy to apply and loved by professionals and homeowners alike. Sometimes this can take longer depending on the type of stone used, and whether there was enough water used during the application.

Final Cleaning: Clean the surface carefully with a fine hair broom so that all JOINT-IT residue is removed. This simple to use, sweep-in jointing grout means gets the job finished faster and stands the test of time. Our unmatched range includes everything to enhance any garden and most can be used as indoor tiles or outdoor slabs. Where other grouts and mortars can crack and loosen, allowing weeds to grow, Joint-It Simple sets rock hard. To get the best results from Joint-It Simple, joints must be a minimum width of 3mm and a depth of 25mm for the joint to have stability when it is set.We ideally recommend a 6:1 sand and cement base, Joints must be a minimum of 3mm wide and 25mm deep to ensure the product is stable and secure in the paving joint. Due to higher rates of driver shortages than usual, we currently advise allowing an additional day or two on top of the specified timeframes, in case of delays. The paving should not be walked on for approximately 24 hours after application in temperatures of around 20° Celsius. Joint-It Simple's natural sands harden on contact with air, so simply wet the area, brush in the product, and leave it to do the rest. These highly porous stones would benefits from being pre-sealed to prevent drawing any of the colour of Joint-It Simple into the stone.

It is specially formulated with seven unique specialist types of glue to ensure that it will stay in your joints for many years. However, it may be useful for others to know that there must be no soil underneath where you're filling as the weeds quickly grow again and push through the filler. Contact with air makes Joint-It Simple harden which is why you must use plenty of water on your paving slabs before you open and tip-out the bag. Our natural sands harden on contact with air, so simply wet the area, brush in the product, and leave it to do the rest. Because Joint-It Simple is activated when it comes into contact with air, the product hardens more quickly in warmer climates.Joint-It Simple is used to fill the joints between Porcelain, Sandstone, Limestone, Slate, Concrete, Yorkstone, Granite, Ceramic and Quartz paving slabs and setts. If a power washer is required, we recommend no more than 1500 PSI or 100 Bar water pressure, using a standard spray jet and not a turbo spinner. As long as the joints are a minimum of 3mm wide and 20mm deep, and that the base is water permeable. Joint-It Simple brush in paving jointing compound is a 97% natural, eco-friendly, non toxic paving grout.