Most DIYers can handle basic plumbing tasks, as long as they have cleared up any questions on code. Sometimes, though, poor decision-making not lack of know-how gets in the way.
You are watching: Can a vent pipe have an elbow
Tim Elder, an inspector for Snohomish County, north of Seattle, Washington, recalls the DIYer who was working with black plastic (ABS) drain pipe.
"ABS joints are easily glued with an inexpensive cement, but this homeowner had dispensed with the glue and simply wrapped each joint with duct tape," Elder recalls. "(The homeowner) said he figured he would just undo the tape and glue the joints if we caught him."
Fortunately, he was caught, glue was used, and his drain didn"t weep and seep whatever effluent it carried.
Don"t get caught making these eight common DIY plumbing "corrections," which often wind up as mistakes:
1. Downhill. How water runs is just as important as the direction in which it runs-otherwise, it may plug. The slope for drains needs be only 1/4 inch per foot, or one inch for every four feet. Changes in slope beyond that should be made with 45- or 90-degree fittings, not by bending the pipe.
3. Wye not. Connections to horizontal drain lines should be made with wye (Y) fittings. The fitting called a "Sanitary Tee" looks like it could do the job, but it doesn"t. A sanitary tee cannot be laid on its back, horizontally: It is shaped differently than the wye and should only be aligned vertically, or it may block up.
4. Some like it hot. Water to tubs and showers cannot exceed 120 degrees. The tub or shower must have temperature-limiting devices, or there needs to be a mixing valve at the hot-water tank to keep the water from exceeding 120 degrees. The thermostat on the hot water tank is not an acceptable temperature control.
5. Well grounded. Plumbing that rests on the ground -- in a trench or under a concrete slab -- should be on a firm base. The drain pipes should not flex or have soft spots, if the inspector walks on them.
7. Nail protection. Protective nail plates and stud guards should be used anywhere that pipes are within an inch of the edge of a stud. The protection should extend 1.5 inches beyond the diameter of the pipe.
8. It"s a gas. Venting pipes that stick out of the roof must be 10 feet from, or three feet above, a window or air intake, including skylights that open. Otherwise, objectionable and toxic sewer gases could encroach upon your home, causing your guests to flee what they believe is a dangerously flatulent host.
"Plumbing isn"t that difficult," a do-it-yourselfer once said. "Water runs downhill, unless it"s under pressure, in which case it goes everywhere." And while soldering copper pipes or gluing plastic can be easy, the catch to plumbing is in the details. A plumber gets paid the big bucks because he knows the plumbing code and is supposed to get things right the first time. If you"re restoring an old home, also check out the useful articles in Old House Web"s Restoration Guide: Introduction to Heating and Plubming.
See more: Dallas County Clerk 509 Main Street, 2Nd Floor, Suite 200, Dallas, Texas 75202
Despite some simple aspects, proper plumbing can be daunting for the DIYer, so if you must plumb the depths of your home"s pipes, be sure to inspect this list of eight things the plumbing inspector will look for when giving your pipes to the "Go to flow." Or save yourself the hassle and contact a local certified plumber.